back
Antec Phantom DP502 Fans
Ignore MSI
and Fan Control software
Fan control
click for motherboard connection details
MSI BIOS can sort DC (3-wire) vs PWM (4-wire) fans:
motherboard manual (page 42)
reboot into BIOS:  shutdown /r /fw /f /t 0
YouTube:
Airflow
click for details
power supply
- Separately from other case airflow,
its fan draws air in thru Antec bottom case filter, exhausting out back.
- case fan arrows
- molded into fans, blade rotation and airflow directions
- most case fans have label on hub:  input side
- unlabeled motor location spider is typically on the exhaust side
- Both Antec fans have label on (exhaust) motor location spider;
- one Antec fan has blades reversed...
5 Arctic 3-wire fans are plugged into Antec's fan and LED controller,
which can control speed for up to six 3-wire fans
from a single PWM (4-wire) motherboard fan control as FAN6
3 front input Arctic fans
  see BIOS FAN settings
- exhausting into Antec case front filter
attached to motherboard FAN6
- 2 top exhaust Arctic fans
- mounted behind 5.25-inch optical drive
attached to motherboard FAN6
- 1 rear case exhaust Antec fan
- mounted backwards, as received..
replaced by Scythe KazeFlex 120 PWM fan
attached to motherboard SYS_FAN1
- 1 chamber Antec fan
- mounted above PSU chamber, drawing air from lower front input,
exhausting to GPU; attached to motherboard FAN4
- 1 PWM ID-Cooling fan
- exhausting into heat sink fin stack
attached to motherboard CPU_FAN1
BIOS FAN settings in Hardware Monitor   see Fan control
CPU fan (CPU_FAN1 ) defaulted to Auto and around 790rpm;
switched to PWM.
Back fan (SYS_FAN1 ) defaulted to DC and ~ 950 rpm
switched to smart based on CPU temp
0% @34C, 8% @46C, 90% @70C ~ 936rpm @39C
Antec fan controller (SYS_FAN6 ) defaulted to DC and ~ 1800rpm,
switched to PWM and smart based on System..
around 15% still reports 1090rpm and louder than wanted...
Antec DC chamber fan (SYS_FAN4 )
switched to smart based on PCH
MSI Center fan tuning: Features > User Scenario > (Fan on) > Customize (clover)
CPU Fan
24 Aug 2023:  KazeFlex 120 PWM fan replaced rear Antec fan
reconfigured SYSFan1 to PWM in BIOS;
new SYSFan1,5,6 curves for reduced idle noise
Fan1:  rear exhaust now Scythe KazeFlex PWM
Fan5:  Antec chamber fan below GPU
Fan6:  5 Artic fans by Antec controller
Antec controller poorly matches Arctic case fans,
which run fast at very low PWM % needed for quiet low load operation.
Replacing puny stock Antec fan with Scythe's KazeFlex significantly altered airflow;
most heat now flows out PC rear instead of top, with less noise.
Case air pressure may now be negative,
wanting top exhaust fans driven separately from front intake fans.
|