By now, may folks will have encountered products with both hardware and software,
but separately documented as if either were functional without the other.
Murphy Bed Depot attempts something comparable for the F-200 bed frame,
with one page (51) of not particularly useful notes that each customer
will need to sort when or whether to apply.
Meanwhile, separate F-200 assembly instructions mention the cabinet twice,
on pages 2 and 6. While seemingly of better quality
than the cabinet,

frame instructions are correspondingly worse.
"Murphy Slat Beds are packed in 2 boxes."
- Which of 4 actual boxes did not count?
Section 2, step 2 - "Place the bolt heads on outside."
- outside of what?
- Unclear which bolt holes allow later adjustment.
Section 2, step 4
Section 4 Photo 1 - "using vice grips"
- Insane; instead use long shaft #1 Phillips screwdriver or equivalent
to pry upper spring end, first using Yoke Connector bar as a fulcrum.
Section 4 step 16
- short video is wanted for "slipping" slat ends into holders.
Section 4 step 18
- With springs (4 each side) to balance with mattress,
frame does not stay down without mattress,
which must be removed to add springs.
|